Related Manuals for POSEIDON 2710
Summary of Contents for POSEIDON 2710
- Page 1 JETSTREAM REPAIR INSTRUCTIONS SECOND STAGE DEMAND VALVE EXPLODED VIEW Art. No. 2725, 2941, 2961, 3546 Low pressure hose with saftey valve Low pressure valve Servo valve Housing complete Switch 1.0:E10...
-
Page 2: Second Stage
JETSTREAM SECOND STAGE 2710, 2941, 2961, 3546 Removal: 1. Disconnect the low pressure hose from the second stage. 2. Remove the low pressure valve from the housing (15) with a screwdriver. Make sure the servo valve needle is not bent. Be sure... - Page 3 JETSTREAM Removal: 1. Remove the servo valve (14). 2. Unscrew the stop screw (9) and remove the valve tube (12). Remove the o-rings (11) (13) with an o-ring remover. Make sure the sealing surfaces are not damaged. 3. Remove the rubber plate (10). 4.
- Page 4 JETSTREAM When servicing the regulator the following parts should be replaced: See chapter Servicekit. 1. All o-rings. Also the ones in the low pressure hose. CLEANING: If corrosion or salt deposits occurs, place all metal parts – concentrated Hempocid* or 15% Hydrochloric acid for about 10 minutes.
- Page 5 JETSTREAM SECOND STAGE Assembly: 1. Mount the o-rings (5,3) on the valve housing (4). Use the tools. See diagram. 2. Install the valve insert (6) in the valve housing (4). 3. Place the o-ring (7) in the groove of the valve insert (6). Lubricate the thread.
- Page 6 JETSTREAM 5. Install the o-rings (11,13) on the valve tube (12). Grease the threads and the o-rings. 6. Screw in the valve tube (12) until about 2 mm space remains as illustrated. 7. Install the rubber plate (10). Screw in the set screw (9).
- Page 7 JETSTREAM Assembly: 1. Fit the purge button in the cover (25) for the second stage. Make sure that the spring is undamaged. 2. Position the diaphragm (24) with the diaphragm washer facing down wards and the hole positioned as illustrated. 3.
Need help?
Do you have a question about the 2710 and is the answer not in the manual?
Questions and answers