Status Remote Control - Motorola ST7000 Product Information Manual

The remote control messages can be sent to a group or individual radios.
A controlled radio receives over the air control information using SDS type 4 with Transport Layer (TL)
on the specific PID number defined in the codeplug. If the received control message is originated from
one of the Individual Short Subscriber Identities (ISSI) present on the radio authorized ISSI list, the
radio executes received command and sends a response.
If configured by service provider upon the reception of SDS Remote Control Service (AT command)
request, the radio gives an audio-visual notification.
The service provider has two options: Limited SDS RC and Full SDS RC modes.
The SDS remote control in the Limited SDS RC enables the following:
• Switching between TMO or DMO modes (read, change, notify) for individual radio and group using
the +CTOM AT command.
• Selecting a talkgroup (read, change, notify) for individual radio and group using the +CTGS AT
command.
• Reading and setting the scanning state using the +CTSCAN AT command.
• Collecting Network Information from individual radio - Network Registration Status and Cell Signal
Quality using respectively the +CREG and +CSQ AT commands.
• Reading individual radio GPS position using the +GPSPOS AT command.
• Setting volume level for individual MT using the +CLVL AT command.
• Rebooting the radio using the R AT command.
• Terminating a call using the H AT command.
• Call forwarding using the +MCCFWD AT command.
The SDS remote control in the Full SDS RC enables the radio to use most of the AT Commands. To
see which AT Commands are not supported, refer to the AT Commands Programmer`s Guide.
2.18

Status Remote Control

Status Remote Control is a feature that provides limited control of the radio, unlike Short Data Service
(SDS) Remote Control.
NOTICE: Only one type of remote control can be active on a radio; either SDS or Status.
The following tasks can be assigned remotely to a radio:
Play loud tone until user interaction
The radio plays a loud tone until you unlock the Touch User Interface (if needed) and press the
Back touch icon. The tone is played through the speaker even if an accessory is attached.
NOTICE: The tone is not emitted when the radio is in one of the following states:
• In a call.
• Temporarily disabled.
• Pseudo Off Mode.
• Ambience Listening Mode.
• Tx-I Mode.
• Emergency Mode.
Send Feedback
MN002955A01-AA
Chapter 2: Services and Features
51