Mitsubishi Electric Lossnay VL-220CZGV-EB Handbook page 36

( 9 ) Remove the motor (DC) from the EA fan assembly
1 Remove the nut (special nut (M8)) that fixes the centrifu-
gal fan to the motor shaft, and remove the spring wash-
er, centrifugal fan, and special washer.
(6) 1.
2 Unscrew the screw (one PTT screw 4×14, indicated by
), and remove the cord clip.
Assembly precaution
Run the motor lead through the guides (three locations,
indicated by ), and make sure the motor lead is se-
curely in place.
Tightening torque:
1.1 ± 0.2 N . m
3 Remove the motor (DC). → See (6) 2.
( 10 ) Remove the Thermistor
1 Check that LED4 (red) on the control circuit board is OFF.
2 Disconnect the thermistor lead connector (CN22, indi-
cated by ) from the control circuit board.
3 Remove the thermistor lead from the cord clampers.
4 Unscrew the screw (one PTT screw 4×14, indicated by
), and remove the cord clip.
Precaution
When removing the thermistor without removing the
Lossnay core, a short-legged screw driver is required.
At this time, be careful not to damage the Lossnay core.
Tightening torque:
1.1 ± 0.2 N . m
5 Remove the thermistor from the main unit.
→ See
Motor (DC)
Power circuit board
Cord clamper
Thermistor
─ 36 ─
Cord clip
LED 4
Control circuit board
Thermistor
Cord clip