Intended Use; Product Compatibility - Siemens 7MF03 Series Compact Operating Instructions

Introduction

2.5 Product compatibility

2.4

Intended use

Overview
Depending on the variant, the pressure transmitter measures corrosive, non-corrosive and
hazardous gases, vapors and liquids.
You can use the pressure transmitter for the following measuring tasks:
● Gauge pressure
● Absolute pressure
● Differential pressure
With the appropriate configuration and the necessary add-on parts (e.g. limiters and remote
seals), you can also use the pressure transmitter for the following measuring tasks:
● Level
● Volume flow
● Mass flow
● Volume
● Customized characteristic curve
The output signal for all measuring tasks is a direct current of 4 to 20 mA.
You can install the "intrinsically-safe" or "flameproof enclosure" version of the pressure
transmitter in hazardous areas. The devices have a test certification and comply with the
corresponding directives.
Pressure transmitters with remote seals of various shapes can be provided for special
applications. For example, measuring high-viscosity substances is a special application.
Operate the device in accordance with the specifications in section Technical data (Page 63).
2.5 Product compatibility
The following table describes the compatibility between the edition of this manual, the device
revision, the engineering system and the associated EDD.
Edition
09/2018
06/2018
12
Comments Product compatibility
Manual re‐ HART 7
vised
FW: 1.00.08 or higher
HW: 1.00.00 or higher
First edition HART 7
FW: 1.00.08 or higher
HW: 1.00.00 or higher
Compatibility with device integra‐
tion package
SIMATIC PDM V9.0 or higher
AMS Device Manager V13 or high‐
er
DTM Pactware V4.1 SP4
FC475 V3.9 or higher
SIMATIC PDM V9.0 or higher
AMS Device Manager V13 or high‐
er
DTM Pactware V4.1 SP4
FC475 V3.9 or higher
SITRANS P320/P420 with 4 to 20 mA/HART
Compact Operating Instructions, 09/2018, A5E38874562-AB