Miele KFN 29683 D obsw Operating And Installation Instruction page 100

Changing the door hinging
 Remove cover  and refit on the
opposite side.
 Turn holder  through 180° and
screw it into position in the two
opposite slots in the hinge plate.
 Secure hinge plate  on the opposite
side, starting with screw  in the
middle at the bottom.
 Then screw in the other two
screws .
 Insert hinge pin  complete with
washer and adjusting foot.
Important. The lug on the hinge pin
must point to the back again.
100
Changing the middle hinge
plate over
 Pull off cover .
 Unscrew hinge plate  with the
protective film underneath.
 Turn hinge plate  through 180° and
screw it with the protective film into
position on the opposite side.
The protective film protects the
appliance housing from damage.
 Turn grey plastic cover  through
180° and refit it in the hinge plate.
Tip: Plastic cover  fits over the
protruding bearing bush so that this is
covered from underneath and from the
side.
 Turn cover  through 180° and refit it
on the opposite side.