Using The Iron - Morphy Richards Saturn Steam Manual

RN305000 MUK Rev1.qxp_IB 17/10/2017 12:10 Page 7

Using the iron

1) Filling the tank
Make sure the iron is not plugged in. Fill the water tank
the side of the water tank, this shows the MAX level of water that the tank can hold and should be
checked whilst filling and the iron is tilted.
TO PROLONG THE LIFE OF THIS IRON, WE RECOMMEND A MIX OF 50% TAP WATER AND 50%
DISTILLED, DEIONISED OR DEMINERALISED WATER, ESPECIALLY IN HARD WATER AREAS.
Never use battery topping up fluid or water containing any substances like starch, sugar, fragrant
additives or defrosted water from a refrigerator.
NOTE: Please see point 2 of 'Exclusions' on page 12.
Re-filling during use
If the water level is too low, the unit will not produce steam. If this happens, open the filling cap
refill with water.
2) Temperature Selection
Plug the appliance into a mains outlet, a beep
will be heard. Press the on-off / temperature
decrease button
The 1-dot temperature setting indicator
the digital display
temperature is reached, at which point the 1-dot
temperature setting indicator will remain
constant and two beeps will be heard.
4)
Dot 1
The appropriate temperature setting indicator
will flash until the desired temperature is reached,
at which point two beeps will be heard. Begin
ironing when the temperature indicator
illuminates constantly. If you turn the temperature
down, wait until the temperature indicator stops
flashing before continuing ironing.
(1) to switch the product on.
(19)
(10) will flash until the
Dot 2 Dot 3 Max
(11) via the filling hole
3)
If a different temperature is required to suit the
garment (see 'Temperature guide' on page 6),
you may adjust the temperature as follows:
on press either the temperature increase
temperature decrease button
until the required temperature setting indicator
(19) is displayed.
WARNING: Keep hands and body away from
the hot soleplate (18).
NOTE: The temperature setting will reset
between each use. When the iron is plugged in
it will require switching on and the required
temperature selecting.
(19)
(6) to the MAX graphic on
(12) and
(2) or
(1) repeatedly
7