Basic Maintenance Schedule - Generac Power Systems Magnum MLT3060M Owner's Manual

Maintenance
Verify the oil is correct for special operating conditions
such as a change in season or climate.
• DO NOT start the unit if the engine oil level is
below the ADD mark on the dipstick.
• Normal operating level is in the cross-hatch
pattern between the full and add markings on
the dipstick.
• Add oil only if the oil level is below the add mark
on the bottom of the cross-hatch pattern on the
dipstick. DO NOT OVERFILL the crankcase.
•
Check the fuel level.
•
If the unit is connected to a remote start or transfer
switch, make sure the remote switch is also off and
tagged.
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to bleed the fuel lines.
Refer to the engine operator's manual supplied with the
unit.
34

Basic Maintenance Schedule

Refer to the original equipment manufacturer's operating
manual for a complete list of maintenance requirements.
Failure to comply with the procedures as described in the
engine operator's manual will nullify the warranty,
decrease performance and cause equipment damage or
premature equipment failure. Maintenance records may
be required to complete a warranty request.
Use the schedule in the following tables as a guide for
regular maintenance
replacement copies of the engine operator's manual,
contact a Generac Mobile Products Authorized Dealer.
Owner's Manual for MLT3060M-K Light Tower
intervals. For additional or