Table of Contents
Advertisement
Site Considerations
The Gilson Testing Screen is a ruggedly-constructed ma-
chine that will provide years of service if installed correctly
and maintained properly� Most cases of poor operation are
caused by faulty installation� Problems can be avoided by
careful planning before placing the machine into service�
Anchoring to Concrete Floors
Gilson recommends using lag shield anchors with lag
screws to anchor the machine to a poured concrete floor
(Fig� 1)� However, anytime local codes apply, you MUST
follow the anchoring methodology specified by
the code�
Fig. 1: Concrete Anchoring
Weight Load
NOTE: Install the machine on a level, rigid foundation�
Gilson recommends a poured concrete floor.
Make sure that the surface where the machine is placed
will bear the weight of the machine and the weight of the
testing materials� Additionally, consider the weight of the
operator and any dynamic loading that may occur when
operating the machine�
Machine Elevation
An elevated foundation for the machine allows for easier
tray handling� However, this also elevates the loading area�
Space Allocation
Provide enough space around the machine for adequate
operator material handling, the installation/removal of the
screen trays, and maintenance on the machine�
Physical Environment
The physical environment where the machine is operated is
important for safe operation and longevity of machine com-
ponents� For best results, operate this machine in a dry en-
vironment that is free from excessive moisture, hazardous
or explosive atmospheres, or extreme conditions� Consider
the noise and dust created by the machine and ensure that
there is adequate ventilation for safe operation�
Extreme conditions for this type of machinery are generally
those where the ambient temperature range exceeds
104°F (40°C) or the relative humidity range exceeds
20%–95% (non-condensing)�
Electrical Installation
Place this machine near an existing power source� Make
sure all power cords are protected from traffic, material
handling, moisture, chemicals, or other hazards� Make sure
to leave enough space around machine to disconnect the
power supply or apply a lockout/tagout device, if required�
Installation
WARNING:
Read all safety warning and instruc-
tions before installation. Failure to follow the warn-
ings and instructions may result in electric shock,
fire, and/or serious injury.
CAUTION:
DO NOT connect the Testing Screen
to an electrical power source until you have mounted
the machine to its intended foundation, verified that
the machine is wired as ordered and is appropriate
for your power source.
DANGER:
You must use lifting equipment to lift
and install this machine. Inspect all lifting equipment
to make sure it is in working order and rated for the
load before attempting to lift. Ignoring this warning
may lead to serious personal injury or death.
NOTE: Note: 230V/50Hz models are shipped without a
power plug�
6
Hide quick links:
Advertisement
Table of Contents
