Electrical Safety ����������������������������������������������������������4 Hydraulic Pump - Gilson TS-1 Operating Manual

Electrical Safety
DANGER:
Electric Shock Hazard. Touching some
of the internal components can cause serious per-
sonal injury or death. Disconnect the power supply
before removing covers or performing maintenance
on the machine.
WARNING:
Electric Shock Hazard. Improper use
of the grounding can result in electric shock. Do not
plug the machine into an outlet until it is properly
installed and grounded.
WARNING:
The supply voltage must correspond
to that stated on the identification plate and in the
technical specifications. NEVER use any other type
of power supply.
WARNING:
Remove plug from the mains immedi-
ately if the cable is damaged or cut.
• This machine must be grounded� In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the elec-
tric current� This machine is equipped with a cord having
a grounding wire with a grounding plug� The plug must
be plugged into an appropriate outlet that is properly in-
stalled and grounded in accordance with all local codes
and ordinances�
• Do not modify the plug provided with the machine: if it
will not fit the outlet, have a proper outlet installed by a
qualified electrician.
• Consult a qualified electrician or service technician if
the grounding instructions are not completely under-
stood, or if doubt exists as to whether the machine is
properly grounded�
• If it is necessary to use an extension cord, use only a
3-wire extension cord that has a 3-blade grounded plug,
and 3-slot receptacle that will accept the plug on the
machine� The marked rating of the extension cord shall
be equal to or greater than the electrical rating of the
machine�
• Make sure that the power cord does not come into con-
tact with hot objects, wet or oiled surfaces, and/or sharp
edges�
• The power cord should be checked regularly and before
each use to check for signs of damage or wear� If the
power cord is worn or damaged, replace the cord�
• Do not use the power cord to remove the plug from the
socket or move the machine�
SAVE THESE INSTRUCTIONS
4