Advertisement
IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY
ASSEMBLY OPERATING INSTRUCTIONS
To assemble feeding tray...
1
Booster seat mode...
1
NOTE: Only suitable for parent chair with: Seat width not less than
375mm. Seat depth not less than 332mm. Seat back height not less
than 310mm. Seat back width not less than 385mm.
Removing seat pad...
1
HOW TO CARE FOR YOUR CHILDCARE SEAT
Cleaning
This product has been designed and developed with safety, comfort and functionality in mind. Please take the time to read this manual
carefully before using this product and keep it in a safe place for future reference. To ensure the long-lasting use of your Seat, wipe down with
a damp cloth and use a mild soap solution if necessary. Do not use abrasive cleaners. Always store product in a clean, dry place to air dry.
Maintenance
Always check parts regularly for tightness of screws, nuts and other fasteners – tighten or replace if required. To maintain the safety of your
toddler seat, seek prompt repairs for bent, torn, worn or broken parts. Use only those parts and accessories approved by CNP Brands.
1a.
Align the feeding tray with the feeding
tray slots located on both sides of the
seat.
1b
Slide the feeding tray along the tray
slots on the seat, until the locking
buttons 'click' into place.
NOTE: Always check that the tray
is properly secure before use.
Feeding tray must always be
used when in booster seat mode.
1a.
Place the Booster Seat on the seat of
the parent chair.
Ensure the back of the Booster Seat is
pressed up against the backrest of the
parent chair.
1b
Secure the first seat fixing belt around
the seat of the parent chair.
1c
Tighten the seat fixing belt adjuster to
ensure the belt is secure.
1d
Secure the second seat fixing belt
around the backrest of the parent chair.
1e
Tighten the seat fixing belt adjuster to
ensure the belt is secure.
1a.
Unfasten the safety harness.
Feed the 3 points of the safety harness
1b
backward through the holes of the
seat pad.
Lift seat pad up and out of the seat for
1c
cleaning.
NOTE: To re-install the seat pad,
complete these steps in reverse.
Ezi Feed
To remove feeding tray...
1
Floor seat mode...
1
Safety harness...
1
2-in-1 Booster
Model # 043052
1a.
Press and hold the locking buttons on
both sides of the tray.
1b
Whilst still holding the locking buttons,
slide the feeding tray away from the
seat.
1a.
Remove feeding tray from seat.
1b
Place seat directly onto the floor.
NOTE: NEVER use floor seat mode
on an elevated surface.
1a.
To fasten safety harness, insert the left
and right hand side buckles into the
buckle housing.
1b
To release safety harness, press the
button on the buckle housing.
NOTE: Always adjust the waist
straps to fit the child correctly.
Advertisement
