Button Sewing - AEG 63Z Instruction Manual

Manual for Model 63Z

Button sewing

06
2.5~4.5
1
1
Change the presser foot with the button
sewing foot.
Move the drop feed control to lower the feed
dogs.
Lowered position
1
Position the work under the foot. Place the
button in the desired position, lower the foot.
Select zig-zag pattern. Adjust the stitch
width to "2.5-4.5" according to the distance
between the two holes of the button.
Turn the handwheel to check that the needle
goes cleanly into the left and right holes of
the button.
If a shank is required, place a darning
needle on top of the button and sew.
Pull end of the upper thread to the reverse
side of the fabric, then tie it with the
bobbin thread.
For buttons with 4 holes, sew through the
front two holes first, push the work forward
and then sew through the back two holes.
Please Note:
When you finish the work, move the drop
feed control to raise the feed dogs.
Raised position
1
46