AEG 63Z Instruction Manual page 50

Manual for Model 63Z
Darning stitch
1
Position the fabric so that the needle is
2mm (1/16 inch) in front of the area to be
darned and then lower the presser foot
lever.
Before lowering down the presser foot,
please hold the front tip of the BH presser
foot to keep it straight by left hand; then
lowering the presser foot lever by right
hand so as to get a perfect evenly finish.
Pass the upper thread down through the
hole in the presser foot.
Pull down the buttonhole lever.
The buttonhole lever is positioned behind
the bracket on the buttonhole foot.
Gently hold the end of the upper thread in
your left hand and then start sewing.
Darning stitches are sewn from the front of
the presser foot to the back, as illustrated.
Please Note:
If the fabric does not feed because it is too
thick, increase the stitch length.
If the sewing range is too big to sew we
suggest to sew several times (or cross sew)
to get a better sewing result.
48