Installing/mounting
3.4 Installation steps
①
Stringer
④
Cross bar
3.4.2
Device with mounting bracket
1. Position the RBSS mounting bracket against a structural cross member so the sensor
wheel rides in the middle of the return belt. See RBSS with mounting bracket (Page 11).
2. Drill and fasten or tack-weld the RBSS mounting bracket in place.
3. Position the RBSS between the bracket arms, and insert pin. Insert pin clip into pin.
4. Run the belt to check that the wheel is riding straight on the belt and is not pulling to
either side. If necessary, reposition the bracket until the wheel runs true.
12
②
Tack-weld
⑤
Return belt
Operating Instructions, 07/2018, A5E45419003-AA
③
Washers (2 places)
Milltronics RBSS