Programming Examples - Viking K-1900-3 Product Manual

3. Programming a Keyless Entry Code Without a Phone Number
You are allowed to program a keyless entry code in a memory location without programming a
phone number. This is useful when you need to assign keyless entry codes for people that are
not tenants in the complex (guards, maintenance workers, etc.) The memory location becomes
dedicated to keyless entry storage. This is programmed by entering "#Q" (skipping the phone
number entry) + the keyless entry code (4-6 digits) + "#" + the memory location (001-250).
Example: #Q 123456 # 001
4. Adding a Master Keyless Entry Code
The master keyless entry code is simply an additional keyless entry code in memory position
000. This is useful when you have a full 250 tenants and require one additional entry code for
a non-tenant (guard, maintenance, etc.) This is programmed by entering "#Q" (skipping the
phone number entry) + the keyless entry code (4 - 6 digits) + "#" + the memory location 000.
Example: #Q 123456 # 000
5. Adding a Maintenance Personnel Keyless Entry Code
Five maintenance personnel keyless entry codes are available, occupying memory positions
251 - 255. This is useful when you require additional entry codes for a non-tenant (guard,
maintenance worker, etc.) These would ordinarily be assigned temporarily and then cleared
when no longer needed (see number 6 below). This is programmed by entering "#Q" + the
keyless entry code (4 - 6 digits) + "#" + the memory location (251 - 255).
Example: #Q 123456 # 251
6. Deleting the Phone Number and/or Keyless Entry Code for One Memory Location
While in programming dial a "#" + memory location (000 - 255) to clear. Note: It is not possible
to erase only the phone number or the keyless entry number. If either number needs to be
changed, BOTH numbers must be reprogrammed.
7. Deleting All Phone Numbers and Keyless Entry Codes
While in programming, enter "###". This will clear all phone numbers, entry codes and set all
programming back to the factory settings. CAUTION: All phone numbers and keyless entry
codes will be permanently erased.
D. Programming Examples
These examples would be entered after accessing programming as shown in section A.
Programming the K-1900-3...
1. ...to dial 555-1234 when a "1" is entered at the entrance phone
2. ...to dial a 9 and pause 3 seconds prior to dialing all numbers
3. ...to activate the door strike/magnetic lock when the tenant dials a "66"
4. ...to set keyless entry code for tenant 3 to "9876" with phone number 555-1234
5. ...to set a keyless entry code for tenant 4 to "9876" without a phone number
6. ...to delete the keyless entry code and phone number for tenant 5
7. ...to set a maximum call time of 10 minutes
8. ...to set the master keyless entry code to "123456"
5
Enter Digits
5551234 #001
9 ##2
66 ##4
5551234#Q9876 #003
#Q9876 #004
#005
10 ##6
#Q123456 #000