Security Code - Viking K-1900-3 Product Manual

3. Local Programming Without the Security Code (from the Entry Phone)
Move dip switch 1 switch to the ON position
Step 1.
(see diagram right).
Take the phone connected to the PHONE
Step 2. port off-hook. A double beep will indicate
that programming has been entered.
Step 3. Program as shown in section B - G.
When finished, dip switch 1 must be placed
Step 4. back in the OFF position for normal
operation (see diagram right).
To exit programming, simply hang up the
Step 5. entry phone (push the "Call" button on the
K-1700-3).
B. Security Code
A six digit number may be used to access the programming mode. The security code has been
factory set to 845464 (V-I-K-I-N-G). It is recommended that you change the security code to a
personal 6 digit number as follows:
Step 1. Access programming as shown in section A.
Step 2. Enter your new security code followed by ##5.
To exit remote programming, enter ##7 or do not enter any touch tones for at least 20 seconds. To
Step 3.
exit local programming simply hang up the entry phone.
Note: The security code must be six digits in length and MUST NOT contain a Q or #. If you have forgotten your
security code, see section "A. Local Programming Without the Security Code."
C. Tenant's Phone Numbers and Keyless Entry Codes
The K-1900-3 can be programmed with up to 250 tenant phone numbers and up to 250 keyless
entry codes, a master keyless entry code, and 5 maintenance entry codes. A tenant may activate
the door strike from the entry phone by dialing a "#" followed by their keyless entry code. When a
given tenant moves out of the complex, the phone number and keyless entry code for that tenant
may be cleared without affecting any other tenant's phone numbers or their keyless entry codes.
Likewise, maintenance keyless entry codes may be assigned temporarily and cleared when no
longer needed. Note: A keyless entry code may be programmed without a phone number.
1. Programming a Phone Number Only
While in programming, enter the tenant's phone number + "#" + memory location number (001
- 250). Example: 5551212 # 001
2. Programming a Phone Number and Keyless Entry Code
Note: Keyless entry codes MUST be programmed while programming the phone numbers into
the memory locations (001 - 250). While in programming, enter the tenant's phone number +
"#Q" + the keyless entry code for the tenant (4-6 digits) + "#" + memory location number (001
- 250).
Example: 5551212 #Q 123456 # 001
VIKING
LINE IN
ON
OFF
4
MODEL K-1900-3
©
VIKING
ELECTRONICS
HUDSON, WI 54016
APARTMENT ENTRY
SYSTEM
PROGRAM
1 1 2 3 4 5 6 7 8 9 10
PHONE
on
1 2