3.1
Introduction
II
The Flex+Drive
kits). The user must only connect the AC power supply and serial cable. A PC will be necessary to run the
WorkBench v5 software.
3.1.1
Controls and indicators
Power on/off switch
AC power socket
24V output
(not used)
Analog input
control
Output
LEDs
MN1917
demonstration unit is supplied with all necessary wiring already connected (except for upgrade
Off
Figure 1 - Control panel layout and AC power location
On
Fuse Compartment
Disable
Enable
Off
On
3
Setup
3
250V, T5AL
Master encoder
(handwheel) input
Drive enable LED
Drive enable switch
Input switches
Setup 3-1