Using The Rotary Commander - Sony XR-C8220 Operating Instructions Manual

Using the rotary
commander
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
TUNER n CD* n MD* n TAPE
Pressing (MODE) changes the operation
in the following ways;
• Tape transport direction
• Tuner : FM1 n FM2 n AM
• CD unit* : CD1 n CD2 n ...
• MD unit* : MD1 n MD2 n ...
* If the corresponding optional equipment is
not connected, this item will not appear.
Tip
When the POWER SELECT switch is set to position
B, you can turn on this unit by pressing (SOURCE)
on the rotary commander.
14
By rotating the control
(the SEEK/AMS control)
Rotate the control and release it to:
•Locate the beginnings of the tracks on the
(MODE)
•Locate a specific track on a disc. Rotate
•Tune in stations automatically. Rotate and
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorized on the
•Change the disc.
Other operations
Rotate the VOL control to
adjust the volume.
tape. Rotate and hold the control
momentarily, the release it to fast-wind
the tape. To start playback while fast-
winding the tape, press (MODE).
and hold the control until you locate the
specific point in a track, then release it to
start playback.
hold the control to tune in a specific
station.
number buttons.
Press (ATT) to
attenuate the
sound.
Press (OFF) to turn
off the unit.