DURKOPP ADLER 867 Instruction Manual page 51

9.2. .2 Directly calling up and changing parameters of the operation level with the sewing-drive control
DA32 G
9.2.2 Reducing the maximum rotation speed with the sewing-drive control DA32 G
All manuals and user guides at all-guides.com
–
Switch on the main switch
–
On the display appears the value for the maximum rotation speed
for example “
–
Actuate the key “
–
Actuate the key “
–
By actuating the keys “
digit can be altered
–
Actuate the key “
0
“0 0 ”
–
By actuating the keys “
digit can be altered
–
Actuate the key “
–
By actuating the keys “
digit can be altered
–
The selected parameter is set
–
Actuate the key “
on
example “
–
By actuating the key “
–
By actuating the key “
–
Actuate the key “
–
After the setting of one parameter you can either call up and
change the next parameter or leave the programming level by
actuating the key “
maximum rotation speed for example “
In order to adapt the maximum rotation speed of the machine best to a
given application, a reduction of the maximum rotation speed is
possible
During the sewing and when the machine stops, the maximum
rotation speed appears on the display The displayed three-digit value
has to be multiplied by 10
rotation speed can be altered by actuating the “
The setting range lies between the parameter values F-111 (max
value) and F-121 (min
See the chapters 9 1 4 and 9 1 6
Hint!
There are two setting s for the maximum rotation speed: The value of the
parameter 111 and the reduction of the max rotation speed after
actuating the keys “+/-” The priority is always given to the lower value! If
the maximum rotation speed has been reduced through actuating the
“+/-” keys, an increase of the parameter value 111 is only activated when
the reduction is cancelled by actuating the “+” key during sewing
CAUTION!
The maximum rotation speed (the value of parameter 111) should
not be set higher than indicated in the parameter sheet (with the
accessory set) for the respective class and subclass
480
” = display for 4800/min
P
”, the first parameter “
>>
”, the first digit of the parameters blinks “
+ -
” or “ ” the numeric value of the blinking
>>
”, the second digit of the parameter blinks
+ -
” or “ ” the numeric value of the blinking
>>
”, the third digit of the parameter blinks “0 0
+ -
” or “ ” the numeric value of the blinking
E
”, the value of the set parameter is indicated for
”
-
” you can switch from “
+
” you can switch from “
E
” and the next parameter is called up
P
” On the display appears the value for the
While it is being displayed, the maximum
value)
0.0.0.
” is displayed
0
0 0 ”
on oFF
” to “ ”
oFF on
” to “ ”
480
” = display for 4800/min
+ / -
” keys
0
”
*
49