DURKOPP ADLER 867 Instruction Manual page 50

9.2. Changing parameter values in the operation level with the sewing-drive control DA32 G
9.2. . Successively calling up and changing the parameters of the operation level with the sewing-drive
control DA32 G
48
All manuals and user guides at all-guides.com
LED
LED1 on
LED2 on
LED1 and LED2 off
LED3 on
LED4 on
LED3 and LED4 off
LED5 on
LED6 on
LED7 on
LED8 on
Display
The parameter values of the operation level (see list of parameters in
chapter 9 1 3) can be altered without entering a code number
–
Switch on the main switch
–
On the display appears the value for the maximum rotation speed
480
for example “
–
Actuate the key “
E
–
Actuate the key“
002
“ ” is displayed
+
–
Actuate the key “
-
–
Actuate the key “
E
–
Actuate the key“
E
–
Actuate the key “
004
“ ” is displayed an so on
(In this way all parameters of the operation level can be
successively called up and altered
programming in the operation level must be ended)
or you can end the programming in the operation level at any time
P
–
Actuate the key “
P
–
Actuate the key “
ended On the display appears the value for the maximum rotation
speed
480
for example “ ” = display for 4800/min
–
After ending the programming in the operation level the altered
values are memorized
Function
Display for single initial bartack
Display for double initial bartack
Initial bartack off
Display for single final bartack
Display for double final bartack
Final bartack off
Display for automatic sewing foot lifting
upon stop in the seam
Display for automatic sewing foot lifting after
the thread trimming
Display for initial needle position = bottom
Display for the initial needle position = top
3-digit display for speed, parameters and code
numbers
” = display for 4800/min
P 0.0.0.
”, the first parameter “
”, the respective parameter value for example
”, the parameter value increases
”, the parameter value decreases
0.0. .
”, the next parameter “
”, the value of the parameter “
After the last parameter the
”, the same parameter “0 0 1 ” is displayed
”, the programming in the operation level is
” is displayed
” is displayed
0.0. .
” for example