Playing A Lullaby - Topcom BABYTALKER 3500 SEDS User Manual

Babytalker 3500 SEDS
– Repeatedly press button
– Press button
27
– Repeatedly press button
– Press button
27
– Press button
23
9.3 Checking the Link Between the Parent Unit and the Baby Unit
You should always check the wireless link when you use the babyphone for the first time.
– Put the parent unit in the same room as the baby unit, separated by at least two metres.
– Switch on both devices. The parent unit will try to establish a connection with the baby unit.
– The green Link LED
The LED stays on continuously after a connection has been established.
21
– The sounds picked up by the microphone
– The volume of the reproduced sound is indicated by the volume LEDs
The higher the volume, the more LEDs are on.
– An audible tone is generated when the maximum volume is reached.
– If no connection is established, a double beep tone is generated as a warning and the Link LED
– Reduce the distance between the parent and baby units until a new connection is established.
9.4 Finding the Parent Unit (Paging function)
– Press the Paging button
it.
– In response, the parent unit will emit a high-pitched tone for 30 seconds. This makes it easier to find the
parent unit.
– Briefly press the On /Off switch
9.5 SEDS Switch Setting
The Babytalker 3500 SEDS is based on the unique Smart ECO Distance Switch
(SEDS) technology, which lets parents set the radiated power of the equipment. There
are two choices: 'long distance mode' or 'ECO' mode with reduced power consumption
and lower radiation.
Set switch to:
16
– 'LONG' for a maximum range of 600 m (free space).
– 'ECO' to reduce the radiated power by half and reduce power consumption. With this setting, the range is
reduced to a maximum of 300 m (free space).
9.6 Talking With Your Baby
You can use the babyphone to talk with your baby.
• Allow your baby to get used to the talk function before you use it in practice.
– Press the Talk button
– Hold the parent unit vertical with the microphone approximately 10 cm from your mouth, and speak into
the microphone.
– Release button
PTT PTT
9.7

Playing a Lullaby

There are three pre-programmed lullabies that you can play on the baby unit.
You can configure lullaby playback on the parent unit (see "9.8.5 Setting the Lullaby") or on the baby unit.
– To play the currently selected lullaby or stop playback, press button
– To select a different lullaby, repeatedly press button
9.8 Settings
9.8.1 Setting the Reproduction Volume of the Parent Unit
There are six volume settings. The lowest setting is 'Volume Off'.
– Press button
26
– Press button
28
until 'Language' is displayed.
26
. The current language is displayed.
or until the desired language is displayed.
26 28
to confirm the language.
to exit the menu.
on the parent unit blinks while it is trying to establish a connection.
21
20
on the baby unit and hold it pressed for at least 2 seconds before releasing
6
on the parent unit to switch off the tone.
29
on the parent unit and hold it pressed.
24
PTT PTT
when you have finished talking.
24
to increase the volume.
to decrease the volume.
are reproduced by the parent unit.
17
until the desired lullaby is displayed.
7
at the top of the parent unit.
21
SEDS
LONG
16
ECO
on the baby unit.
10
blinks.
7