Download Print this page

Appendix E - Recovering The Passkey - Eggtimer Rocketry Proton User Manual

Board reva9; software rev. 1.01a

Advertisement

Appendix E – Recovering the Passkey
Like any secured WiFi network, you need two things to connect... the SSID and the passkey.
The SSID of your Proton will be "Proton_nnnnnn" where nnnn is the last 6 hexadecimal digits of
your device's MAC address (a unique address given to every Ethernet device). The SSID is
broadcast, so you should be able to see it in your device's WiFi manager.
The passkey is an eight-digit number generated by a random number algorithm the first time that
your Proton is powered on, and is saved in EEPROM memory at that time. It's going to be
unique for every Proton. There should be a label on the little baggie that the WiFi module came
in with the passkey (you kept it, right?), but it's easy to get it if you lose it...
To get the passkey, connect a USB-Serial cable (the same cable that's used with all Eggtimer
Rocketry products) to the 3-pin header as follows:
BLACK wire – GND
WHITE wire – TX
GREEN wire – not used
Using an ASCII terminal program such as TeraTerm or HyperTerminal, connect to the serial port
at 115,200 baud, 8 bits, no parity, 1 stop bit. Now connect the battery on your Proton. You
should see the following information:
(a few lines of garbage... part of the boot process)
Note that there is a space between the first four digits of the passkey and the second four digits,
that's just to make it easier to read; when you actually enter the passkey don't type the space.
Disconnect the battery, and remove the serial cable. You won't need the cable again unless you
forget the passkey, or you need to flash the software.
Now, fire up your device's WiFi manager. Connect the battery to your Proton... you'll hear the
buzzer beep 3 times then stay on for a second, and in about 10-15 seconds you should see your
Proton's SSID on your WiFi manager. Connect to the SSID using the passkey that you obtained
earlier (but don't put the space between the digits!), and you should see the Proton's status page.
You're now connected to your Proton, and ready to start using it.
Proton v1.01a
SSID: Proton_2abcd
PASSKEY:
3718 6501
- 57 -

Advertisement

loading