Load A Project - Allen-Bradley Logix 5000 Series Programming Manual

Store and Load a Project Using a Memory Card

Load a Project

When the store operation is finished, you remain offline.
For procedures on loading and removing the SD card in the card slot,
refer to the ControlLogix System User Manual, publication 1756-
UM001 available at
http://literature.rockwellautomation.com/idc/groups/literature/documen
ts/um/1756-um001_-en-p.pdf.
Follow these steps to use the Logix Designer application to load the project
from a memory card.
ATTENTION: During a load operation, all active servo axes are turned
off. Before you load a project, make sure that this does not cause any
unexpected movement of an axis.
Important:
1. Go online with the controller.
Rockwell Automation Publication 1756-PM017H-EN-P - February 2018
Make sure the SD card is unlocked if set to load On Power Up
before using the ControlFLASH software. Otherwise, the updated
data may be overwritten by firmware on the SD card. An error
message appears. Refer to the ControlLogix System User Manual,
publication 1756-UM001 available at
http://literature.rockwellautomation.com/idc/groups/literature/docum
ents/um/1756-um001_-en-p.pdf, before updating.
Chapter 1
21