Siemens Sinumerik 840D sl Diagnostic Manual page 244

Overview of Alarms
NCK alarms
16000 [Channel %1: ] Block %2 invalid value for lifting direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direction (key-
word: ALF=...) which lies outside the permissible range (permissible value range: 0 to 8) was pro-
grammed .
With active cutter radius compensation:
Code numbers 2, 3 and 4 cannot be used in G41
Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the contour.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program the lifting direction under ALF=... within the permissible limits.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16005 [Channel %1: ] Block %2 invalid value for lifting distance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mistake in programming: the value for the lifting path must not be negative.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16010 [Channel %1: ] Block %2 machining stop after lift fast
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel is stopped after the
lift motion has been carried out.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: After the channel stop, the axes must be retracted manually in JOG and the program aborted with
Reset.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16015 [Channel %1: ] Block %2 wrong axis identifier %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Axis names from different coordinate systems were used to program axes for LIFTFAST. The retrac-
tion movement is no longer clear.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Use axis names from one coordinate system.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-244
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009