Siemens Sinumerik 840D sl Diagnostic Manual page 200

Overview of Alarms
NCK alarms
14260 [Channel %1: ] Block %2 pole angle too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In redefining the pole with G110, G111 or G112 in polar coordinates, the value range of the pole angle
specified under keyword AP=... has been exceeded. It covers the range from -360 to +360 degrees
with a resolution of 0.001 degrees.
Definition of terms:
- Specification of end of block point with polar angle and polar radius, referring to the current pole (pre-
paratory functions: G00/G01/G02/G03).
- New definition of the pole with polar angle and pole radius, referring to the reference point selected
with the G function. G110 ... last programmed point in the plane, G111 ... zero point of the current
work, G112 ... last pole
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct NC part program. The permissible input range for the polar angle is between the values -360
degrees and +360 degrees with a resolution of 0.001 degrees.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14270 [Channel %1: ] Block %2 pole programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: When defining the pole, an axis was programmed that does not belong to the selected processing
level. Programming in polar coordinates always refers to the plane activated with G17 to G19. This
also applies to the definition of a new pole with G110, G111 or G112.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program. Only the two geometry axes may be programmed that establish the cur-
rent machining plane.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14280 [Channel %1: ] Block %2 polar coordinates programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of the displayed block has been programmed both in the polar coordinate system (with
AP=..., RP=...) and in the Cartesian coordinate system (axis addresses X, Y,...).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Correct the NC part program - the axis motion may be specified in one coordinate system only.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14290 [Channel %1: ] Block %2 polynominal degree greater than 5 programmed
for polynominal interpolation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: A polynominal degree greater than five was programmed for the polynominal interpolation. You can
only program polynomials up to the 5th degree.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
2-200
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009