Setup 4: 3× Spectra 212 Line Source With Additional Subwoofer - K&F SPECTRA 212 User Manual

User's Manual
8.4
If you want to use the K&F SPECTRA 212 as a line source in full-range mode, configure the speaker for
the line source mode as described in chapter 'Operating mode: Line source' at page 13. Select the ap-
propriate preset on the K&F SystemAmp or K&F SystemRack. Whenwiring your system, be sure to assign
the channels correctly (see page 19). You can link up to three K&F SPECTRA 212 in parallel. The resulting
overall load impedance is 2.7 Ohm per channel.
Presets:
K&F SystemAmp:
K&F SystemRack:
Suggested configurations include:
(3x)
K&F SPECTRA 212
(Line Source)
(3x)
K&F NOMOS XLT
Page 22 of 35
Setup 4: 3× SPECTRA 212 line source with additional subwoofer
SPECTRA 212 LS LCut
With a cluster of 3 setup, enable the switchable Cluster of 3 filter
in the Input EQ of the K&F SystemAmp.
3xSpec212 LS LCut
By default, the crossover frequency between the subwoofer and
the top is 100 Hz. If you prefer a lower frequency (for example, the
subwoofer and the top will be located relatively far apart from
each other), you might want to select the full-range mode for the
K&F SPECTRA 212 while feeding the subwoofers in 60-Hz mode.
Version 1.5
K&F SPECTRA 212
© KLING & FREITAG GMBH