Protecting The Speakers, Reliability - K&F SPECTRA 212 User Manual

User's Manual
3.4
Be sure to connect the K&F SPECTRA 212 speaker to a K&F SystemAmp or a K&F SystemRack.
Never feed audio at excessive levels to the speaker. This may be caused by mixing consoles, equalizers,
effect equipment, etc. and should be indicated on this equipment. Clipping at the power-amp output is
typically shown by a red clipping indicator. In any case, be sure to lower the signal level once it sounds
distorted.
For damage caused by
•
•
we do not assume warranty and excludes liability for possible consequential damage.
Signals that may damage the speakers include the following:
•
•
•
Never place your speakers
•
•
•
Damage Caused by the Speaker's Magnetic Fields
Even when not connected, loudspeakers continuously produce a magnetic field. Therefore, when trans-
porting or placing the speaker, be sure to keep a minimum distance of about 1 meter between the
speaker and magnetic disks or computer/video displays.
Page 12 of 35

Protecting the Speakers, Reliability

overloading the speakers or
using the speakers without K&F SystemAmp or K&F SystemRack
Continuous high-volume signals at high frequencies, continuous audio feedback
Continuously distorted signals at high levels
Sounds occurring when connecting, disconnecting, or switching on a device on the audio system
while the speaker is on
where they are permanently exposed to direct sunlight,
where the devices are exposed to high moisture or rain.
where they are exposed to strong vibrations or dust.
Version 1.5
K&F SPECTRA 212
© KLING & FREITAG GMBH