K&F SPECTRA 212 User Manual page 17

User's Manual
9)
Tip
10)
11)
© KLING & FREITAG GMBH
To prevent damage to the inside
threads, confirm that you can see the
threads in the K&F VariQunit from out-
side through the mounting bore.
If you want to use the K&F SPECTRA 212
as a line source in full-range mode, con-
figure the speaker for the line source
mode as described in chapter 'Operat-
ing mode: Line source' at page $$.
Replace the previously removed screws
to fasten the K&F VariQ unit.
Tighten the screws lightly by hand.
When aligning the grille, make sure
that the K&F logo is at the bottom.
Put the grille into position.
Risk of thread destruction due to incor-
rectly screw placement!
Always make sure that the grille edge
fully lies on the enclosure surface and
be sure to screw the screws in fully ver-
tically to the enclosure side.
Fully press the entire grille edge onto
the enclosure while screwing in.
Version 1.5
K&F SPECTRA 212
Page 17 of 35