Table of Contents
Advertisement
User's Manual
8.2
If you want to use the K&F SPECTRA 212 as a line source in combination with a subwoofer, be sure to
configure the VariQ unit properly. Select the appropriate preset on the K&F SystemAmp or K&F System-
Rack. Whenwiring your system, be sure to assign the channels correctly (see page 19).
Presets:
K&F SystemAmp:
K&F SystemRack:
Suggested configurations include:
(1x)
K&F SPECTRA 212
(Point Source)
(1x)
K&F NOMOS LT
(1x)
K&F NOMOS LS2
8.3
Presets:
K&F SystemAmp:
K&F SystemRack:
© KLING & FREITAG GMBH
Setup 2: 1× K&F SPECTRA 212 point source with additional
subwoofer
SPECTRA 212 PS LCut
To ensure optimum load distribution on the K&F SystemAmp, we
recommend using channels 3 and 4 for the K&F SPECTRA 212 and
channels 1 and 2 for the subwoofers.
Spec212 PS LC
By default, the crossover frequency between the subwoofer and
the top is 100 Hz. If you prefer a lower frequency (for example, the
subwoofer and the top will be located relatively far apart from
each other), you might want to select the full-range mode for the
K&F SPECTRA 212 while feeding the subwoofers in 60-Hz mode.
Setup 3: 2× K&F SPECTRA 212 line source in full range mode
SPECTRA 212 LS FR
With a cluster of 2 setup, enable the switchable Cluster of 2 filter
in the Input EQ of the K&F SystemAmp.
2xSpec212 LS FR
(1x)
K&F SPECTRA 212
(Point Source)
(1x)
K&F NOMOS XLT
(1x)
K&F NOMOS XLS
Version 1.5
K&F SPECTRA 212
Page 21 of 35
Advertisement
Table of Contents
