Radio Operation; Restoring Factory Settings; Muting Button Beep Sounds; Aligning Source Levels - Aiwa CDC-X317 Operating Instructions Manual

Adjusting sound

You can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass)
1
Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode's indicator flashes.
2
Turn the Smart Jog to increase or decrease the level
for the selected mode (except for H-BASS).
In H-BASS mode, turn the Smart Jog to select on or
off.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source mode's
volume to almost the same level.
1
Press FNC repeatedly to select the desired mode.
2
Press DISP while pressing SEL.
"LA 0" appears in the display.
3
Turn the Smart Jog to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
1
Turn off the unit.
2
Press and hold DISP until "LA --" appears in the
display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, and H-BASS, and aligned source
volume levels.

Muting button beep sounds

1
Turn off the unit.
2
Press and hold SEL until "bEEP" appears in the
display.
3
Turn the Smart Jog to select on (level indicators
appear) or off (level indicators disappear).
4
Press and hold SEL until the unit turns off.
3 3
ENGLISH ENGLISH
Setting the clock
1
Press and hold DISP until the clock indicator flashes
in the display.
2
Press TUNEi (to set hour) or TUNEk (to set
minute) and turn the Smart Jog.
3
Press DISP.
Displaying the clock
1
Press DISP.
To return to the former display, press DISP again.

RADIO OPERATION

Tuning in to a station

(Seek/Manual Tuning)
Stereo indicator Local indicator
Band indicator Frequency indication
1
Press FNC repeatedly to select the desired band
(FM1, FM2, FM3, AM1 or AM2).
2*
Press TUNEi (to move to higher frequencies) or
TUNEk (to move to lower frequencies) to tune in to
a station.
"ST" appears in the display when a station is
broadcasting in stereo, and receiving conditions are
good.
*Seek Tuning and Manual Tuning
• Press and hold TUNEi or TUNEk until seek Tuning
starts.
The unit locates a station automatically (Seek Tuning).
• Press TUNEi or TUNEk repeatedly to search for a
desired station while increasing or decreasing the
frequency step by step (Manual Tuning).
To stop Seek Tuning, press TUNEi or TUNEk
again.
Monaural mode
When signals become weak, or reception becomes
poor, the unit automatically switches to Monaural mode
to reduce noise.