E602 - Samsung RC090MHXEA Service Manual

E602

On the back of the controller you can see 8 dip switches; these are used to programme the
unit. If you hold the remote controller with the red sensor at the top from factory all of them
are switched off. Down
Switch 1 is on the left, if switch 4 is set to on or up the controller will not start up properly, all
that will be seen is some flashing lines going in a circle under schedule, and will show E602
error after 5 mins.
www.freedomhp.co.uk ©G Hendra Nov 18 41