Before The First Usage; First Steps; Setting Up The Appliance; Adjust The Infinite Slice-Thickness Setting - Bifinett Food Slicer KH 150 Operation And Safety Notes

Safety / Before the First Usage / Operation
ance repaired at an authorised service centre
or by an other suitably qualified specialist.
J
Use the appliance with the supplied accesso-
ries only.
No claims under the warranty nor a liability for
damages will be accepted if they result from
improper or incorrect use of the slicer.

Before the First Usage

Q

First steps

Q
j
Carefully remove the slicer from its packaging,
remove all packaging materials and keep them
together with the main packaging.
j
Clean the slicer before it comes into contact
with any foodstuffs (see also the chapter
'Cleaning').

Setting up the appliance

Q
Specific safety advice on the
placing of the appliance
1. Never set the slicer up on a hot surface or near
an open flame.
2. Ensure that the power cable does not pass
over hot or sharp-edged objects.
3. Do not allow the power cable to become kinked
or trapped and do not wrap it around the slicer.
j
Set the slicer up on a flat, non-slip surface
close to a power socket.
j
Unwind the required length of power cable
Insert the plug into the power socket.
j
Place the food carriage
table with guide slot
blade cover high standing side down, so
6
that the holding clamps (on the underside of the
food carriage ) engage. Ensure that these
10
have correctly engaged, in that you check the
mobility of the food carriage.
Pull to the front for removal of the food
carriage from the guide slot
10
from the support table.
8 GB
8
on the supporting
10
. Now press the on the
9
and lift it
9
j
Push the food holder plate
carriage.
j
Place the catch tray
table and on the housing such that the sliced
foods can fall in there directly and without
hindrance after being cut.
Adjust the infinite slice-thick-
Q
ness setting (see Fig. D)
Through variable tightenings of the adjusting
screws you can determine the movement rate
16
of the infinite slice-thickness setting
j
Screw both of the adjusting screws
with the screwdriver
j
Check, by turning the infinite slice-thickness
control knob
14
rate is suitable.
If it is not,
- loosen both adjusting screws
movement rate or
- tighten both adjusting screws
stiffer movement rate.

Operation

Q

Working advice

Q
Specific safety advice for
slicing and for the handling of
the appliance
1. Never touch the blade when the slicer is in
. operation!
There is a risk of grave personal injury!
2. Always use the food carriage
holder plate
11
(Exception: very large pieces of foodstuff).
Press the pieces of food to be sliced forward
using the food holder
3. Use the slicer only for cutting normal house-
hold foods and not for other purposes. Do not
use the slicer for cutting deep-frozen foods,
bones, foods with large kernels or for the
slicing of still packaged foods.
on to the food
11
below the support
17
.
14
tight
16
.
15
, to see if the desired movement
for a lighter
16
further for a
16
and the food
10
.
.
11