Standards / Regulations - Wolf ComfortLine Series Installation And Maintenance Instructions Manual

Standards / Regulations

Standards and regulations
Observe all current Building Regulations and
other local requirements.
Only recognised heating contractors may install
WOLF boilers. This heating contractor will also
be responsible for the proper installation and
the commissioning of the heating system.
The boilers described in these installation
instructions are low temperature boilers
according to HeizAnlV and 92/42/EEC
(Efficiency of Hot Water Boilers).
Locate the enclosed operating instructions in a
clearly visible position in the boiler room.
Boilers may only be installed and operated in
boiler rooms which are suitable according to
the Landes-FeuVo [or local regulations].
The following regulations, rules and guidelines
must be observed during installation:
• Boiler room guidelines or Building
Regulations relating to the construction
and installation of central boiler rooms and
fuel storage facilities.
• Energy Savings Act (EnEG) and related
directives (Heating Systems Order).
4
• DIN standards
DIN 1988 Technical rules for DHW
installations
DIN 4701 Rules for calculating the heat
demand of buildings
DIN 4751 Part 3 - Safety Equipment
for heating systems with flow
temperatures up to 95 °C
DIN 18160 Domestic chimneys
• VDE requirements:
VDE 0100 General information
regarding the installation of
HV systems with rated
voltages up to 1000V
VDE 0105 Operation of HV systems,
general considerations
VDE 0722 Electrical equipment of
non-electrically heated
heat generators
VDE 0470/ Protection through housings
EN 60529
EN 60335-1 Safety of electrical
equipment for domestic use
and similar purposes
Note: Please read these instructions
carefully before the installation and
keep them in a safe place.