Using Wireless Communication Hardware - Texas Instruments TI-Nspire CX Getting Started Manual

1. Use a small screwdriver to release the panel from the back of the
handheld.
2. Remove the panel.
3. Insert the white connector into the jack located at the top of the
battery compartment, as shown.
4. Thread the wire into the case to secure it. Insert the rechargeable
battery into its compartment.
5. Replace the back panel and fasten the screws with a screwdriver.

Using wireless communication hardware

Teachers using TI-Nspire™ Navigator™ Teacher software in the classroom
can use wireless network adapters along with the TI-Nspire™ access
point to establish wireless communication between TI-Nspire™ CX
handhelds and their computer. The wireless cradle can be used to
establish a wireless connection between the teacher's computer and any
TI-Nspire™ handheld. This section provides information about how to
attach wireless communication hardware to a TI-Nspire™ handheld.
Attaching a wireless adapter to a handheld
The TI-Nspire™ CX wireless network adapters work with the TI-Nspire™
CAS and TI-Nspire™ CX CAS handhelds. The battery in the TI-Nspire™ CX
handheld powers the wireless adapter. To connect the handheld to the
wireless adapter:
1. Position the wireless adapter on top of the handheld so the connector
on the adapter lines up with the connector on top of the handheld.
Wireless
network
adapter
(school-
owned)
Connector
2. Slide the adapter into position, making sure the guides on the sides
of the adapter slide into the grooves on the sides of the handheld.
68 Configuring the TI-Nspire™ CX handheld
Guides for
aligning
with
handheld