Configuring The Ti-Nspire™ Cx Handheld; Checking Battery Status; Recharging The Handheld - Texas Instruments TI-Nspire CX Getting Started Manual

Configuring the TI-Nspire™ CX handheld
This chapter provides information needed to:
• Maintain batteries used in the handheld
• Change the default settings
• Attach a wireless module when the handheld is used in the classroom

Checking battery status

To check the status of the TI-Nspire™ Rechargeable Battery in a
handheld:
c
1. Press to access the
5 4
2. Press
3. Click or press
OK
Note: From an open document, press

Recharging the handheld

To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect
it to either of the following power sources:
• A standard USB cable connected to a computer
• A TI USB wall charger (sold separately)
• A TI-Nspire™ CX Docking Station if in a classroom setting
The amount of time required to fully charge the battery may vary, but
charging normally takes about six hours. It is not necessary to remove the
TI-Nspire™ Rechargeable Battery from the handheld to recharge it. The
handheld operates normally while it is attached to a charging source.
Home
to open the
Handheld Status
·
to close the window.
Configuring the TI-Nspire™ CX handheld
screen.
window.
Battery status
is shown here.
~ 7 4
.
55