Dispensers - GE G6S28TSLSS Owner's Manual

Dispensers

Water Dispenser
IMPORTANT:
maintain a fresh supply.
could be caused by low water pressure.
With the water filter installed, dispense 1 cup (237 mL)
seconds or less, the water pressure to the refrigerator
meets the minimum requirement.
cup (237 mL) of water, the water pressure to the
suggestions.
Flush the Water System
Air in the water dispensing system can cause the water
dispenser to drip. After connecting the refrigerator to a
water source or replacing the water filter, flush the water
system.
the water line and the filter, and prepares the water filter
for use. Additional flushing may be required in some
households.
into a wide-mouthed container to flush air from the water
system (it takes approximately 5 minutes to dispense 2
gallons of water).
NOTE: As air is forced from the system water may spurt
out of the dispenser.
Dispenser Drip Tray
There is an insert in the dispenser drip tray. The insert
can be removed from the drip tray to carry to the sink to
empty or clean.
Push down on the rear edge of the insert to tilt up the
front edge for easy removal.
49-60765
To Dispense Water:
1. Select the Water icon on the dispenser controls
and press the container against the ice and water
dispenser paddle.
NOTE:
the water dispenser. Pressing hard could cause foam
or plastic containers to crack.
2. Release the ice and water dispenser paddle, and then
remove the container.
Spigot
Paddle
NOTE:
Allow 3 hours for the refrigerator to cool down and chill
water.
The water dispensing system will not operate when
the left hand refrigerator dispenser door is open or if a
water filter or bypass plug is not installed.
9