Conduct Departure Self-Briefing - Eclipse Aviation Eclipse 500 Flight Manual

c. STALL PROTECTION SYSTEM
• Select STALL PROTECTION and START TEST
• Verify "STALL" appears on ADI and aural "STALL" warning is heard
• Verify stick pusher function activates and control stick moves forward
• Pull back on control stick to overpower stick pusher, then release pressure
• Verify stick continues to push forward after overpower is relaxed
• Select STOP TEST
3. Electronic Circuit Breakers .............. CHECKED
• Select ECB synoptic page and check for tripped/pulled/collared ECBs
4. FLAPS ................................ SET FOR TAKEOFF
• TO or UP, based on preflight performance planning
5. PARKING BRAKE ............................ RELEASED
6. External Lights ...........................AS REQUIRED
• Turn taxi light on when beginning to taxi. Flash the taxi light to signal the ground
crew of intent to commence taxi.
7. Air Source Switch.....................NORMAL (see note)
If OAT is greater than 75°F / 24° C, the Air Source Switch may be set to OFF before and
8. Seats Inertia Reel

Conduct departure self-briefing

TAXI
1. Brakes ..................................................... CHECK
2. Engine Instruments................................ CHECK
12/8/2006
• YD OFF/ON button on the Autopilot Control Panel
• AP OFF/ON button on the Autopilot Control Panel
• AP mode buttons on the Autopilot Control Panel
NOTE
during taxi to reduce air conditioning workload.
FLIGHT TRAINING AND STANDARDS MANUAL
ECLIPSE 500
© Eclipse Aviation Corporation, 2006
TEST
LOCKED
47