Left Engine And Nacelle - Eclipse Aviation Eclipse 500 Flight Manual

5. Rudder, Trim Tab
• Inspect rudder and trim tab and their hinge points for damage. All surface edges
should be inspected for signs of binding.
6. Aft Position Lights
• Inspect aft position lights for damage to lens and internal components.
7. Right Elevator, Trim Tab and Static Wicks (2)
• Inspect static wicks; replace before flight if broken or missing.
8. Left Elevator, Trim Tab and Static Wicks (2)
• Inspect static wicks; replace before flight if broken or missing.
9. Left Horizontal Boot
• Inspect boot for cracks, holes, chips, and wear. A damaged boot may not
inflate/deflate properly which could result in the inability to shed ice. In addition, a
damaged boot may not be held tight against the stabilizer which could result in a
significant loss in aircraft performance.
10. Left VOR Antenna
• Inspect VOR antenna for damage to antenna and antenna surface.
11. Identification Plate
• The identification plate should be firmly attached to the aircraft. The data on the
identification plate should be consistent with the aircraft's documentation.

LEFT ENGINE AND NACELLE

1. Pylon Panels
• Inspect both upper and lower surface of the pylon panels for damage. All pylon
surfaces should be smooth and free of deformities.
2. Variable Outlet Ram Exhaust (VORE)
• Inspect variable outlet ram exhaust for damage/blockage.
3. Engine Exhaust and Bypass Duct
• Inspect engine exhaust and bypass duct for blockage and signs of damage. Care
should be taken when inspecting these components after engine operation as they
will remain hot.
4. Drain Lines (4)
• Inspect all drain lines for obstructions and signs damage.
5. Oil Level and Servicing Door
12/8/2006
FLIGHT TRAINING AND STANDARDS MANUAL
ECLIPSE 500
© Eclipse Aviation Corporation, 2006
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CONDITION
CLEAR
CHECK, SECURITY
37