Eclipse Aviation Eclipse 500 Flight Manual page 43

11. L PFD Circuit Breaker
• Verify circuit breaker pressed in
12. L ACS Circuit Breaker
• Verify circuit breaker pressed in
13. R GEN Switch
14. BUS TIE Switch
15. SYSTEM BATT Switch
16. L GEN Switch...................................................................AUTO
17. ELT Switch....................................................................ARM
18. Passenger Mask............................................................AUTO
19. AIR SOURCE Switch.........................................................OFF
20. External Lights....................................................AS REQUIRED
• Turn Beacon light on.
21. Gear Indication...................................................THREE GREEN
22. Parking Brake.................................................................................SET
• Pulling the parking brake handle without simultaneously depressing the brake
pedals will not engage the parking brake, even though the PARKING BRAKE
status message is illuminated.
23. COMM / NAV......................................................................SET
• Set tower and departure frequencies in comm. #1. Use comm. #2 for all ground
frequencies (ATIS, clearance delivery, ground control, etc). This will allow a simple
change to comm. #1 when ready to talk to tower.
• Set the two navaids likely to be initially used in both nav #1 and nav #2.
24. Altimeter........................................................................SET
• Use ATIS/ASOS/AWOS altimeter setting. If no weather source available, set
airport elevation.
12/8/2006
...................................
FLIGHT TRAINING AND STANDARDS MANUAL
ECLIPSE 500
© Eclipse Aviation Corporation, 2006
SET
SET
AUTO
AUTO
ON
43