TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF TABLE OF CONTENT About this manual Intended use Safety information Assembly parts Removal of old unit Plumbing connection Installation of mounting assembly Electrical connection Attaching discharge elbow Air switch operated...
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF ABOUT THIS MANUAL This user manual applies to several models of the Symbol Meaning device. Thus it may be possible that some of the Warning symbol. Warning against risks described features and functions are not available of injury.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF ASSEMBLY PARTS STOPPER REMOVABLE SPLASH GUARD SINK FLANGE FIBRE GASKET SUPPORT FLANGE UPPER MOUNTING RING MOUNTING SCREWS RETAINER RING CUSHION RING* LOWER MOUNTING RING* MOUNT TAB DISHWASHER INLET * The cushion ring and the lower mounting ring will remain attached to the disposer during installation.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF REMOVAL OF OLD UNIT To remove remaining mounting system from the TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY. sink, loosen the screws, push mounting ring up. Before starting this step, turn off electrical Under it is the snap ring.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF INSTALLATION OF MOUNTING ASSEMBLY Keep the remaining parts placed together in the order they were removed. Before you connect Removable the disposer to the mounting assembly under Sink...
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF Electrical connection Attach disposer onto the upper mounting ring by aligning the three mounting tabs on the lower mounting ring with the slide-up ramps on Connect disposer to appropriate the upper mounting ring and rotating counter household current only.
Page 9
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF ELECTRICAL CONNECTION countertop and at a minimum of one meter from FOR DISPOSER PROVIDED the side of the sink, away from water splashes WITH PREWIRED MOLDED 13 AMP FUSED and out of the reach of children.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF Air switch operated Attaching discharge elbow Disposer Air Switch Assembly MODELS TE-45, TE-75S Connect the waste elbow to the disposer by The Actuator which consists of: sliding the flange against the rubber gasket on the 1.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF OPERATING INSTRUCTIONS Batch feed Your disposer is Continuous Feed if you did not specifically purchase a Batch Feed Disposer. Remove sink stopper. Turn on a medium flow of cold water.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF CAUTION Cold water recommended. Do not use the food waste disposer with hard materials like glass or metal. Turn the machine off or unplug it while trying to unblock a blocked turntable with a wooden spoon.
TE-45 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF CLEANING AND MAINTENANCE DO NOT ATTEMPT TO LUBRICATE YOUR DISPOSER! If used, resulting damage can be easily detected The motor is permanently lubricated. The disposer and all warranties are void. Mineral deposits from...