Viking 40-IP Product Manual page 14

14. Relay Activation Command (Relay Mode must be set to "Door Strike")
The one or two digit code stored in the Relay Activation Command is the touch tone command that the person calling
the 40-IP must enter on their phone in order to momentarily activate the RC-4A relay to control a doorstrike, mag-lock,
gate controller, or other device. The code can contain the characters 0 - 9, # or ,. The code cannot match a relay
latching or toggle command (,1, ,0). The code must be entered while the remote phone is communicating with the
Speaker. Factory Setting: ,, Note: If the access code is programmed it must be entered before controlling relays.
If this security is not needed, leave the access code blank.
15. Relay Activation Time (Relay Mode must be set to "Door Strike")
The value stored in the Relay Activation Time is the amount of time the RC-4A relay will be energized after a correct
momentary touch tone command is entered. This number can range from 0.5 - 99 seconds. Factory Setting: 5 seconds
16. Relay Buzz Volume (Relay Mode must be set to "Door Strike")
The relay activation tone is a buzzing sound that is heard from the speaker when the door strike relay is activated.
After the calling party enters the correct relay activation command, the calling party will hear 2 short confirmation beeps
and the speaker will output a buzzing sound (relay activation tone) while the door strike relay is activated. The tone
(buzz) length will match the relay activation time up to a maximum of 5 seconds. The tone (buzz) can be programmed
to three different volume settings 1 = Low, 2 = Medium, 3 = High or it can be disabled. When Disabled the confirmation
beeps will not be heard. Factory Setting: 3
17. Relay Latch Commands (Relay Mode must be set to "Door Strike")
The Operation Commands (,0 to ,1) to Un-Latch or Latch the relay are enabled. These can be entered on an Inbound
call after the access code is dialed (if programmed).
When set to "Disabled" the Operation Commands (,0 to ,1) to Un-Latch or Latch the relay are disabled. Disabling the
Latch commands can be useful in applications where you want to eliminate the possibility of inadvertently entering a
latch command leaving a gate open/closed, etc. The momentary relay activation command is still allowed.
Factory Setting: Enabled
18. SIP Paging Volume
The SIP Paging Volume can be set from 0 - 19, 0 = lowest volume setting, 19= highest volume setting. Adjusting this
will set the volume level for SIP Paging. Factory Setting: 1
19. Ring Volume
When the Inbound Call Mode (see Programming section 22) is set to Ring, the 40-IP will output a loud ring when it is
called. The volume level of the loud ring can be adjusted from 0 - 19. Factory Setting: 5
20. SIP Page Length Timeout
This feature selects the maximum length of time that SIP Page calls can be connected. Programmable in increments
of 1 minute up to a maximum of 9 minutes or disabled. With the call length disabled, the 40-IP speaker must rely on a
call ended signal or touch tone # to hang-up. Factory Setting: 3 minutes
14