Drive Chain And Sprocket Wear Inspection - Triumph Bonneville T100 2018 Owner's Handbook Manual

• Make sure
marking is aligned with the spindle
adjuster on both sides of the
swinging arm.
• Tighten both adjuster lock nuts to
15 lbf ft (20 Nm) and the rear wheel
spindle nut to 81 lbf ft (110 Nm).
• Repeat the drive chain adjustment
check. Readjust if necessary.
Warning
Operation of the motorcycle with
insecure adjuster lock nuts or a
loose wheel spindle may result in
impaired stability and handling of the
motorcycle.
This impaired stability and handling
may lead to loss of control or an
accident.
• Check the rear brake effectiveness.
Rectify if necessary.
Warning
It is dangerous
motorcycle with defective brakes; you
must have your authorized Triumph
dealer take remedial action before you
attempt to ride the motorcycle again.
Failure to take remedial action may
reduce braking
to loss of motorcycle control or an
accident.
the same adjuster
to operate
efficiency leading
Maintenance and Adjustment
Drive Chain and Sprocket Wear
Inspection
Never neglect drive chain maintenance
and always have drive chains installed
by an authorized Triumph dealer.
Use a genuine Triumph supplied drive
chain as specified in the Triumph Parts
Catalog.
The use of non-approved drive chains
may result in a broken drive chain or
may cause the drive chain to jump
off the sprockets leading to loss of
motorcycle control or an accident.
If the sprockets are found to be worn,
always replace the sprockets and drive
chain together.
Replacing worn sprockets without also
replacing the drive chain will lead to
premature wear of the new sprockets.
the
1. Measure across 20 links
2. Weight
Warning
Caution
1
10-20
KG
2
115