Table of Contents
Advertisement
Step 7
XP17
(6)
The door jambs reinforce the door
opening and provide an attractive
trim. The splice post supports the
rear wall.
1
Position splice post at the center
of the rear wall and fasten using 4
bolts and nuts into rear wall angle
and 2 screws into rear floor frame.
Hint: Measure or count holes to
determine if post is centered on rear.
2
Fasten the top of the door jambs
to the door track with two screws. Do
the same for the bottom into frame.
There must be a 7/8" ( 2,2 cm) gap
between end of ramp and edge of
door jamb. Notched edge faces to-
ward center of building.
middle hole on inside edge of door
jamb with a bolt inside building and a
hex nut with an acorn nut outside, as
shown.
7/8" (2,2 cm) Gap
● Parts Needed For ●
Splice Post/Door Jamb
(4)
(4)
7311
Fasten
Hex Nut
Acorn Nut
STEP
2
(2)
NOTCHED EDGE
MUST FACE CENTER
OF BUILDING
Bolt
3/8" (10 mm)
Washer
7311
17
● ● ● ● ● 5287 Splice Post (1)
● ● ● ● ● 7311 Door Jamb (2)
STEP
1
5287
Advertisement
Table of Contents
