8941 Ramp; 9379 Front Floor Frame; 9377 Rear Floor Frame - Arrow EDA86 Owner's Manual & Assembly Instructions

Step 1
ZB11
(8)
The front floor frame is made up of
three pieces. The rear floor frame is
made up of two pieces. The holes in
these pieces will align when the
pieces are positioned with correct
amount of overlap. The illustrations
below show the proper overall length
for the front and rear. Proceed as
follows:
1
Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the rear floor frames as
shown. The holes in these pieces
will align when the pieces are posi-
tioned with correct amount of over-
lap. See the illustrations below for
the proper overall length of the rear
floor frame. Join the frames by insert-
ing five bolts into frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
● Parts Needed For ●
Floor Frame Assemblies
(5)
STEP
3
9379
8941
STEP
1
9379
DRAIN HOLES FACE
OUTSIDE
STEP
2
9377
11
● ● ● ● ● 8941 Ramp (1)
● ● ● ● ● 9379 Front Floor Frame (2)
● ● ● ● ● 9377 Rear Floor Frame (2)
9379
8941 Frame Assembly
95 7/8" 243,5 cm
9379
Rear Floor Frame
95 7/8" 243,5 cm
95 7/8" 243,5 cm Rear
95 7/8" 243,5 cm
9377
Front Floor
9377
Front