Table of Contents
Advertisement
Step 6
XP16
(22)
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
The top frame pieces give rigidity to
the side walls and provide a surface
for attaching the gables which sup-
port the roof.
1
Position corner posts at the cor-
ner of the floor frame as shown. Fas-
ten the corner post to the floor frame
with two screws.
Support the corner posts with stakes
or other devices until door jambs are
attached.
2
Fasten the door track assembly
(holes on top) behind the top of the
front corner posts using 1 screw in
each corner. See the figure.
3
Fasten the rear wall angle as-
sembly behind the top of the rear
posts using 2 screws in each post.
4
Fasten the side wall angles be-
hind the top of the side posts using 2
screws in each corner. Side wall
angles overlap rear wall angle in cor-
ners.
The floor frame must be square
and level or holes will not align.
● Parts Needed For ●
Posts/Top Frames
5288
SIDE
5288
STEP
4
9342
9378
16
● ● ● ● ● 5288 Corner Post (4)
● ● ● ● ● Door Track Assembly (1)
● ● ● ● ● Rear Wall Angle Assembly (1)
● ● ● ● ● 9342 Side Wall Angle (2)
REAR
TOP VIEW
FRONT
Wall Angles
Must Face
Inside
Building
STEP
5288
SIDE
STEP
1
5288
Short Leg
on Top
STEP
3
Rear Wall
Angle Assembly
9342
Long Leg
On Top
Opening
Facing In
Short Leg
on Bottom
2
Advertisement
Table of Contents
