Welch Allyn TM286 Directions For Use Manual page 62

58 Computer Interface
• During Printing
NO DATA AVAILABLE
This message appears if the
NOT AVAILABLE
This message appears if the
connected.
Data Transfer Program Mode
The Data Transfer Program mode is used to modify the TM286 USB interface
configuration parameters to match the computer's USB Port settings.
Enter the Program mode by selecting the Program (PROG) button. Move the cursor to
Data Xfer Config and press the
The following screen appears the first time the Data Transfer Program mode is entered
showing the factory default settings.
PROGRAM MODE - DATA TRANSFER
* 115.2 kBAUD
57.6 kBAUD
38.4 kBAUD
19.2 kBAUD
9600 BAUD
4800 BAUD
These selections fall into three groups:
• Baud rate
• Parity and data bits
• Flow control
The default setting for each group has an asterisk (*) before it so that it is easy to scan the
settings for each group.
Selecting default settings for any of the groups is achieved in the same manner as the
Program mode. Use the
to the setting that you wish to select. Press the button. The word SAVED will appear in
the lower right corner of the screen and the asterisk (*) will appear in front of the new
setting.
To exit the Data Transfer Program submenu, move the cursor to the
button. This will return to the Program mode which can be exited by selecting Program
(PROG).
button is pressed and no results are stored.
button is pressed and the computer is not properly
button to enter the submenu.
* NO PARITY + 8-BIT
ODD PARITY + 7-BIT
EVN PARITY + 7-BIT
SPC PARITY + 7-BIT
* XON/XOFF DISABLED
XON/XOFF ENABLED
or buttons to move the solid square cursor down or up
Welch Allyn TM286 Auto Tymp
press the