Installing The Battery Pack - Sony TRV312 Operating Instructions Manual

Charging and installing the battery pack
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
• The POWER lamp will remain lit for a while even if the battery pack is removed and
the power cord is unplugged after charging the battery pack. This is normal.
• If the POWER lamp does not light, set the selector to VTR (DC OUT) and disconnect
the power cord. After about one minute, reconnect the power cord and set the
selector to CHARGE again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.

Installing the battery pack

(1) Insert the top of the battery pack into the top of the battery mounting surface.
(2) Push the battery pack. Make sure that you hear clicks twice. Attach the
battery pack to the camcorder securely.
Note on the battery pack
Do not carry the camcorder by grasping the battery pack.
To remove the battery pack
Slide BATT, and then pull the lower part
of the battery pack.
You can look at the demonstration of the functions available with this camcorder.
(p. 28)
1
2
1
2
9