Jøtul F 162 Installation And Operating Instructions Manual page 9

4.6 Fitting the fl ue pipe with the rear
outlet
The product is supplied from the factory with the smoke outlet
fi tted for the top outlet.
NB! Proceed as follows for installation with a rear outlet:
Fig. 4
Lift the baffl e (Fig. 4 A) up carefully.
1.
2. Remove one of the side burn plates by lifting them up a
little and then out. (Be aware if using tools, that vermiculite
plates may be damaged by rough handling).
3. Remove the baffl e.
4. Remove the other side burn plate.
Remove the exhaust defl ectors (Fig. 4 B).
5.
Fig. 5
6. Unscrew the screws (fi g. 5 A) and remove the smoke outlet
(fi g. 5 B) from the top outlet from the inside of the burn
chamber.
Fig. 6a
7. Unscrew the screws (fi g. 6a C) and remove the cover (fi g. 6a
B) from the rear outlet from the inside of the burn chamber.
Fig. 6b
8. Knock out the removable cover plates (fi g. 6b A).
9. Attach the smoke outlet (fi g. 6a A) on the inside of the burn
chamber where the cover was.
10. Install the cover (fi g. 6a B) where the smoke outlet was.
11. Refi t the exhaust defl ectors (fi g. 4 B) and the baffl e plate
(fi g. 4 A).
ENGLISH
9