FCC Caution 1. The device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
End Product Labeling This transmitter module is authorized only for use in device where antenna may be installed such that 20 cm may be maintained between antenna and users (for example access points, routers, wireless ADSL and similar equipment). The final end product must be labeled in a area with the following: “...
Page 4
“FCC RF exposure requirements: SAR compliance has been established in the laptop computer(s) configurations as documented in this OEM Installation Manual, and can be used in laptop computer(s) with substantially similar physical dimensions, construction, and electrical and RF characteristics. Use in other devices such a PDAs or lappads is not authorized. This transmitter is restricted for use with the specific antenna(s) tested in the application for Certification.
Page 5
>>> 1.1 MP54GBT2 (MS-6855B) - Wireless 11g + Bluetooth Combo MiniPCI Card MSI MP54GBT2, the Wireless 11g + Bluetooth Combo miniPCI Card, is a Type IIIB card, which can be used to integrate with such systems as notebook, mini-barebone, PDA, portable PC.
Page 6
>>> 1.2 How MP54GBT2 Works 1.2.1 In WLAN Environment Ad-hoc Mode : An Ad-hoc network is a local area network or other small network, especially one with wireless or temporary plug-in connections, in which some of the network devices are part of the network only for the duration of a communications session.
Page 7
Internet, email, file transfer, and printer sharing. The scale and range of the Infrastructure networking are larger and wider than that of the Ad-hoc networking. MP54GBT2 MP54GBT2 WLAN+Bluetooth Combo MiniPCI Card WLAN+Bluetooth Combo MiniPCI Card...
Page 8
Every Bluetooth device that provides a service must be prepared to respond to a connection request. Bluetooth soft- ware is always running in the background on the server, ready to respond to connection requests. MP54GBT2 WLAN+Bluetooth Combo MiniPCI Card Bluetooth-enabled Devices...
>>> 1.3 Specifications Hardware Form Factor 32-bit Type IIIB Specification Operation voltage 3.3V Antenna Connector Two antenna connectors ® ® Operating System Microsoft Windows 98SE/ME/2000 Environmental - Operating Temperature: 0 ~ 55 - Operating Humidity: 10 ~ 90%, non-condensing Dimensions (WxDxH) 59.75 x 44.6 x 3.5mm Network Standard IEEE 802.11;...
Page 10
IEEE 802.11g: Ch. 1-11 – N. America Channel Ch. 1-13 – Japan Ch. 1-13– Europe ETSI Ch. 10-11 – Spain Ch. 10-13 – France IEEE 802.11b: Ch. 1-11 – N. America Ch. 1-13 – Japan Ch. 1-13– Europe ETSI Ch. 10-11 – Spain Ch.
Page 11
Bluetooth Network Standard Bluetooth v2.0 (Class II) Specification Frequency Band 2.4-2.483 GHz Data Rate Up to 2.1Mbps Channel 79 sub-channels Transmission FHSS (Frequency Hopping Spread Spectrum) Modulation GFSK Antenna Type One antenna connector support Power Consumption 100mA (maximum, continuous TX) Max.
>>> 1.4 System Requirements Before installing MP54GBT2, your PC should meet the follow- ing items: - One desktop/notebook PC with an available MiniPCI slot. ® - Windows 98SE/ME/2000/XP operating system. - Minimum 5MB free disk space for installing the driver and utilities.
>>> 1.6 Product View WLAN 11g antenna connectors Connect to external antennas for enhanced data transmission and reception. The external antennas are well designed on the desktop or note- book computers. Bluetooth antenna Connector Golden Finger...
MiniPCI module, please refer to your computer’s manual. Installing MP54GBT2: Locate the MiniPCI slot on the mainboard.Place your MP54GBT2 over the MiniPCI slot (at an angle of 30 degrees). Then, gently insert it into the slot until the golden finger of the card gets fully inserted.
Setup CD to copy files during the installation. Please NOTE that the MP54GBT2 should be installed into your computer before installing the driver and utility. Then, the operating system will detect a new device and start to con- figure the new device.
Page 16
ST EP Insert the software CD into your CD-ROM drive, and the Setup program should launch automatically. If the Autorun program doesn’t launch automatically, click Start E:\setup.exe at the taskbar and select Run..Type (where your CD-drive) in the Open box and click OK to launch the Setup program manually.
Page 17
Click the Install Bluetooth Driver button. ST EP The welcome screen of InstallShield Wizard appears. Click Next. Read and accept the License Agreement; then, click Next. Click Next to install the driver in the default destination folder. Click Install and the program will copy the necessary files to the system.
Page 18
Example of Antennas Installation The distance between WLAN antennas and the user body (excluding hands, wrists, feet, and ankles) must be more than 20 cm. In the laptop, for example, the antennas can be located on the top of the screen. See the follows as an illustration: WLAN WLAN WLAN...
Need help?
Do you have a question about the MP54GBT2 and is the answer not in the manual?
Questions and answers