Table of Contents
Advertisement
Installation
1. Site Installation
RADAR trapping devices should be sited along wall / fl oor junctions, behind machinery
and equipment, i.e. anywhere where that bait boxes and mouse monitor units (MMU's)
would normally be placed. Trapping devices should be secured with fi xing brackets
if possible to prevent the trapping device being accidentally moved, knocked or
removed by unauthorised persons.
2. Site Survey
(Connect Variants Only)
To assess network signal strength and the number of control panels required for a
site, the Range Check Mode can be used.
With Signal Strength displayed (Icon 5
), hold the
RI Service Key Magnet
over the
sensor for 3 seconds and Range Check Mode will be enabled. The bottom LED will
start to fl ash to show this and give a reading R1 - R9. The signal strength will show
for 1 hour to allow technician to survey the site.
8
Advertisement
Table of Contents
