Installation - Rentokil Connect Radar Instruction Manual

Radar units should be sited along wall / floor junctions, behind machinery and equipment,
i.e. anywhere that bait boxes and mouse monitor units (MMU's) would normally be
placed. Units should be secured with fixing brackets if possible to prevent the unit being
accidentally moved, knocked or removed by unauthorised persons. The unit ideally should
be sited where the LED is clearly visible to signal an activation.
Environmental
Restrictions
Outdoor use
High levels of surface
water
High levels of dust /
grease
Knocking / kicking
Extreme temperature
(<0°C)
High humidity (> 80%)
or condensation
High levels of
vibration
Instruction Manual Connect Radar 2017 Version 1.1 (GSD-100549)

Installation

Details
Radar has been specifically designed for indoor applications
only. The product is not suitable for outdoor use.
The system electronics can be damaged by water. Take
care to locate units away from areas where local high
pressure washing or hosing down operations are carried
out.
It is important that units are kept clean, especially if installed
in areas where high levels of dust or grease are present.
Cleaning guidelines must be followed to prevent damage to
the units.
Care must be taken to locate units away from pedestrian
traffic to avoid false activation. This can be prevented by
mounting units on fixing brackets.
Extremely low temperatures (i.e. unheated warehouses)
could affect Radar's performance and may result in the unit
entering low battery status mode.
High humidity and / or condensation could result in damage
to the unit's control electronics and result in false
activations.
High vibration due to localised machinery / fridge
compressors etc could affect the performance of the unit
and result in false activations.
Page 7